On bench in the shack, is my Flex Radio model 1000D. As you can see, a very clean front panel! The power switch is located in the upper left corner, under the logo. The power switch is a standard rocker type, which controls the main power to the hardware.
Just below the power switch is a 7 pin male microphone connector. The plan here is to use a short "home brew" adapter cable so I can interface a Heil Model PR40 using a standard balanced XLR cable from the microphone.
On the right hand side of the front panel, is the grill work and filter used keep air circulating over the circuit boards which are located directly behind the filter. The circuit boards are mounted horizontally, which helps give the cabinet a lower profile and provides plenty of room for the circuitry. ( The film container is an option ! )
The cabinet measures approx, 4"h x 10"w x 9.5"d. This makes the hardware easy to make fit in almost any place in the shack, keeping in mind that there is a fair amount of cabling between the radio and the PC.
.JPG)
.JPG)
No comments:
Post a Comment